last updated by  Roisin 7 months ago
3 voices
3 replies
  • Author
    Posts
    • #9399 Reply
      Roisin
      Moderator
      • Topics70
      • Replies186
      • Total256
      • Mom Friend
      • ★★★
      • Group Admin

      This is something I starting learning last year at our medieval event we do. Lots of practice needed lol

      The lucet, a horn-shaped tool often made from wood, dates back to the Viking era. Lucets were in common use throughout Europe until the 16th century. A luceted cord is exceptionally strong and slightly springy. It is very useful in period garb, such as the lacing of a bodice.

      STEP 1: Begin by winding your yarn on the LEFT horn, back to front. Continue winding the yarn on the RIGHT horn, back to front, and once again on the LEFT horn, back to front. Allow the tail of the yarn to fall through the hole in the base of the lucet.**Next, bring the yarn across to the front of the right horn. TURN the lucet clockwise with your left hand.

      STEP 2: The process of turning the lucet clockwise will wind the yarn around the lucet properly. You will have an upper and a lower thread on (what is now) the LEFT horn. Lift the lower thread over the upper thread to form your first stitch.

      STEP 3: To begin to tighten down the stitch, pull the working yarn gently to the right.

      STEP 4: After tightening, bring the yarn across to the FRONT of the right horn. TURN the lucet clockwise with your left hand

      STEP 5: Once again, lift the lower yarn on the LEFT horn over the upper to form your second stitch.

      STEP 6: At this point and from now on, you may tighten down your loops by gently tugging on the RIGHThorn loop, pulling it out to the right. This method can allow you to use even tension, thereby creating more consistant stitches, moreso than by tightening the stitches with the working yarn alone.The loop on the right horn may get big, and may be tightened down by tugging on the working yarn.

      STEP 7: After TURNing the lucet clockwise, once again, lift the lower yarn loop on the LEFT horn over the upper to form your next stitch.

      STEP 8: Continue by tigthening down the stitch using a combination of tugging on the right loop and pulling the working yarn to the right, as in the previous steps.

      REPEAT STEPS 5-8 until your cord reachs the desired length.Cut your working yarn leaving about a 6 inch tail. Take the cord off the horn. Run the working yarn through the LEFT loop and gently tighten down that loop. Finally, run the working thread through the RIGHT loop and tighten down.

      Congratulations! You have just completed a basic luceted cord.

      Lucet

    • #9410 Reply
      Greenbird15
      Keymaster
      • Topics1217
      • Replies1145
      • Total2362
      • Queen Bee
      • ★★★★★
      • Site Admin
      • PATRON

      Did you make those cords they’re beautiful. Thanks for sharing this with us!

      • #9437 Reply
        Roisin
        Moderator
        • Topics70
        • Replies186
        • Total256
        • Mom Friend
        • ★★★
        • Group Admin

        wish I did! Hopefully I’ll get to that point!

    • #9419 Reply
      mnm1994
      Keymaster
      • Topics407
      • Replies1698
      • Total2105
      • Queen Bee
      • ★★★★★

      Those are beautiful! What a wonderful skill 🙂

Reply To: Lucet

You can use BBCodes to format your content.
Your account can't use Advanced BBCodes, they will be stripped before saving.